Tonbridge Electrical Inspection Specialists
We carry out clear, evidence-based EICRs and electrical safety checks across TN9, assessing installations to BS 7671, noting defects and explaining their safety significance in plain terms. Our inspections, mindful of heritage wiring, aluminium conductors and listed-building sensitivities, also consider flood-affected properties for corrosion and compromised equipment. The following sections outline our approach, findings and recommended next steps.
Our services
We’ll issue the correct certificate for Kent properties and submit any applicable Part P notifications for work in Tonbridge borough, so you’ve got a compliant record for your local property.
The jobs we are called for most
From fault-finding and EICRs to consumer unit upgrades, rewires and additional sockets, we handle the electrical work Tonbridge properties most often require. We investigate tripping circuits, loss of power, overheating accessories and damaged cabling, then recommend proportionate remedial work. In post-war estates, aluminium wiring needs careful assessment because unsuitable connections can loosen and overheat. Victorian and period homes may require attention to ageing VIR or rubber-insulated cable, while listed properties need sympathetic planning alongside current safety requirements.
For landlords, we support landlord responsibilities with EICRs, remedial repairs and electrical safety certification for rented homes. We also install EV chargepoints, replace unsafe consumer units, add lighting and sockets, and undertake partial or full rewires where test results show deterioration. Emergency call-outs are available when faults create an immediate risk or disrupt essential supplies.
What is included in every job
Every job starts with a clear assessment of the installation, the scope of work and any safety risks identified. We inspect accessible wiring, consumer units, protective devices, earthing and bonding, sockets, switches and connected equipment relevant to the task. Where appropriate, we test continuity, insulation resistance, polarity, earth fault loop impedance and RCD operation using calibrated instruments.
We’ll isolate circuits safely where required, apply safe working procedures and explain any operational disruption before work begins. Our checks consider loading, visible deterioration, signs of overheating, equipment lifespan and the suitability of existing protection for current use. We also review safety signage where isolation points, distribution equipment or hazards need clear identification.
You’ll receive a fixed written price before planned work starts, and we keep the work area orderly. Any urgent danger is made safe promptly, with clear advice on remedial priorities.
Certificates and notification
Once testing and any remedial work are complete, we’ll issue the appropriate electrical certification, such as an Electrical Installation Certificate, Minor Electrical Installation Works Certificate or EICR, to record the work, test results and any observations. Your document identifies the installation, circuits tested, protective measures, limitations and any codes requiring action.
Where notifiable domestic work falls within Part P requirements, we’ll complete certificate notification through the appropriate competent-person process. This supports Building Regulations compliance and provides a record for your property file. For landlords, our EICR documentation supports statutory reporting duties, including clear classification of C1, C2, C3 and FI observations. We’ll explain what each code means, prioritise danger and recommend proportionate remedial action. Keep certificates safely: insurers, managing agents, future electricians and local authorities may need evidence of compliant inspection or completed electrical work.
What it costs
Clear, written pricing helps you plan essential electrical work without compromising safety or compliance. We confirm fixed EICR and landlord pricing before testing begins, including VAT, labour, parts and certification.
| Job | Price | What's included |
|---|---|---|
| EICR, up to 3-bed | £150–£250 | Inspection, testing, report and VAT |
| EICR, 4–5 bed | £250–£350 | Inspection, testing, report and VAT |
| Commercial EICR | £30–£50 per circuit | Circuit testing, report and VAT |
| PAT testing | From £1.50 per item (min £80 visit) | Portable appliance testing and report |
| Fault finding | £80 per hour | Fault diagnosis and recorded observations |
| Emergency attendance | £120 per hour (first hour minimum) | Urgent attendance, diagnosis and advice |
Prices exclude plaster decoration, asbestos removal, DNO supply-upgrade charges and scaffold or access equipment.
How long each job takes
Timescales depend on the size, age and condition of the installation, but we’ll assess access, circuit numbers and any safety concerns before confirming the work required. We’ll isolate circuits where testing demands it, minimise disruption and document limitations that could affect compliance.
| Service | Typical duration |
|---|---|
| Domestic EICR | 2–4 hours |
| Landlord remedial checks | 1–3 hours |
| PAT testing | Minutes per appliance |
| Fixed-wire testing | Half day or longer |
This job breakdown is indicative, not a substitute for inspection. An EICR may take longer where circuits are inaccessible, labels are absent, or faults require investigation. We don’t rush dead tests, live verification or protective-device checks: accurate results depend on safe isolation and full circuit coverage. If remedial work is needed, we’ll explain the findings, provide a written fixed price, and arrange certification after compliant completion.
Property types we work on around Tonbridge
In Tonbridge we work across distinct neighbourhoods with different housing types and ages. In the town centre and neighbouring East Peckham we inspect Victorian and late‑Victorian terraces built c.1850–1900, so we focus there on legacy VIR and rubber‑insulated cables, original earthing arrangements and the extent of any Victorian rewiring. Whether you occupy, let or manage a property in these Tonbridge neighbourhoods, we tailor our inspection and testing to the local area’s typical construction and age so we can clearly identify safety defects and compliance concerns.
Certificates you will receive
Once testing is complete, we’ll issue the certificate that corresponds to the work carried out: an Electrical Installation Certificate (EIC) for a new circuit or consumer unit, a Minor Electrical Installation Works Certificate for an addition or alteration to an existing circuit, and an Electrical Installation Condition Report (EICR) for a condition inspection.
Each document records test results, observations, circuit details and any limitations, providing a compliance record. Where work is notifiable under Part P of the Building Regulations — typically including new circuits, consumer‑unit replacements and certain bathroom work — we self‑certify through NICEIC where authorised to do so and submit the required Building Control notification. (If we are not authorised for a particular job, you may need a separate Building Control application or the work must be notified by the installer.) You’ll receive the relevant Building Regulations compliance documentation; you are not required to arrange a separate inspection if notification is handled by us or another authorised certifier.
We use electronic signatures for secure, traceable certification and can provide renewal reminders for future EICRs. Keep certificates safely: while they do not in themselves transfer legal responsibility, they are an important record for managing electrical safety, meeting landlord obligations where applicable, supporting insurance enquiries and assisting with future alterations.
Areas we cover from Tonbridge
From our base at Pipers Business Centre in Tonbridge (TN9) we provide electrical testing, inspection and certification across the town, including Hildenborough village, Hadlow, East Peckham, Tudeley and Cage Green. We visit terraced and semi‑detached homes in Cage Green and Hildenborough—many dating from the late Victorian and Edwardian periods—post‑war council estates around East Peckham and parts of Tudeley built in the 1950s–1970s, plus more recent 1990s–2000s housing developments on the outskirts of Tonbridge.
In older properties around Cage Green and Hildenborough we commonly encounter older fabric‑insulated and sometimes re‑wired circuits with obsolete fuseboxes; in the post‑war estates near East Peckham and Tudeley we frequently find ring final circuits with ageing PVC insulation and consumer units from the 1960s–1980s that may lack modern RCD protection; on the newer developments to the south and west of Tonbridge we see modern twin and earth cabling and more recent consumer units but still check for correct earthing arrangements and protective device sizing. We will identify safety defects such as unprotected circuits, deterioration of cables, overloading of socket circuits in town‑centre flats, and inadequate protective measures in older houses, then explain the remedial priorities clearly with recommendations tailored to the specific Tonbridge neighbourhood.
We also support electrical safety planning for community events in Tonbridge, for example testing temporary supplies and distribution equipment for fetes on Hadlow, checking generator connections and RCD protection at village events in Hildenborough, and inspecting temporary lighting and sockets for markets in the town centre.